ETPS Success!

[CajunKenny]

Your TPS voltage won't ever get to 3.51. Set it to something like 3.00 and see what happens.

What is your max TPS voltage by the way?

[CarlosPTR210]

Originally Posted by CajunKenny

Your TPS voltage won't ever get to 3.51. Set it to something like 3.00 and see what happens.

What is your max TPS voltage by the way?

TPS max = 3.51

[CarlosPTR210]

Looks like I need to add that gain to the XDF...... You should be able to check it from the keypad. in the Keypad, are all the option in PTT, but the values that i put in the PRO, are not the same in the Kpad, so i set it manuali.

gain:10
Rrps:1888
load:105.5

After the new set points, I check with the multimeter the voltage in the gray wire of the Mpro, and have the same voltage 3.5v, and need to be .45vlts,

By the way, this Mpro unit, have the R7 resistor mod (one side cut)

No, the V Out mode should not be set to 0... Set it to 8 I'll change

[CajunKenny]

Wow...that's the highest TPS voltage I've seen!

Carry on...

[CarlosPTR210]

any update?

[TurboBob]

have you tried changing the setting of V out mode yet?

No, I have not updated the XDF yet.

B

[CarlosPTR210]

Originally Posted by TurboBob

have you tried changing the setting of V out mode yet?

No, I have not updated the XDF yet.

B

I'll change tomorrow and try it,

But why the voltage in the gray wire of the pro, always is 3.51v?

Thank you for your full support.

Best regards.

Carlos.

[TurboBob]

because you have the mode set to 0.

[CarlosPTR210]

Originally Posted by TurboBob

because you have the mode set to 0.

Yep that right, today i changte the seting in the Mpro, so now is the TPS voltage output.

I will test when I drive home to see how is working.


by the way, when the ETPS is activate, how can I adjust the A/F?

Thanks and regards.

CArlos.

[CajunKenny]

ETPS switches to open loop at low boost. So, it will maintain the same AFR's that you would see at WOT.