|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
| Home | Online Store | Product Manuals | Register | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
01-14-2010, 11:22 AM
|
|||
|
|||
I want to run E85!
Hello, anyone there? Thanks in advance for any help. I have a stock computer, GEN II with 3.5 MAF, Walbro pump with hotwire, 3 bar MAP, ported irons, ported intake with EGR deleted, .030 bore and 60lb Motrons, what would I need to convert to E85? Is there a stock O2 sensor off any STOCK vehicle that will work with the GEN II? Would I have to purchase an adapter or could it be hardwired to the GEN II? Thanks again, John
 
|
|
#2
01-14-2010, 04:05 PM
|
||||
|
||||
|
There are a ton of considerations when converting over to E85. I'm no expert, and don't run it, but there's a good forum dedicated to it over at www.turbobuick.com
Hers's a direct link to the E85 forum. http://www.turbobuick.com/forums/e85-technical-forum/
__________________
TurboDave EWCS(SW) USN (Ret.) (1965-1988) My Webshots Email us Sevierville, TN TranslatorPro MAFless fuel, spark, boost and fuel pump management  86 GN(TranlatorPro/ExtenderPro on speed density w/boost control,PLX-WB) 87 GN(stock, for show) 01 Excursion LTD 7.3L PSD(Power Stroke Diesel), Turbo, 4X2 (big puller) 08 Honda Accord EX-L, 3.5V6 270HP (driver)
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
