|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
| Home | Online Store | Product Manuals | Register | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
10-23-2009, 06:17 PM
|
|||
|
|||
MAF wire connector to MAF volts??? strong weak signal
So..... We have a code 34 low maf volts, we put the cont. tester to the three connections at the end of the harness. The middle wire is showing both ground and power with a weak signal. The other wires show strong ground and a strong power. That middle wire is weak and pulls both is this normal?
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
